Cylinder Liners - Installation Engine Assembly (00-02) N14 Page 0-58 Install the o-rings and the crevice seals as follows: 1. Install the crevice seal (1) in the top groove. 2. Install the black o-rings (2 and 3) in the center and the bottom grooves. Caution: Make sure that the o-rings (2 and 3) are not twisted. Twisted o-rings will not seal and will impact liner protrusion. Caution: Lower press fit (LPF) liners must not have seal- ant applied to the counterbore. False liner protrusion and liner damage will occur. Counterbore sealing is accomplished with brass seal rings. Seal rings are available in several thicknesses.
The correct thickness must be chosen to meet cylinder liner protrusion specifications. The desired protrusion is the total sum of the thickness of the liner flange and the seal rings minus the counter- bore depth. Cylinder Liner Protrusion mm in 0.10 MIN 0.004 0.18 MAX 0.007 Lubricate the crevice seal and the o-rings with vegetable oil. NOTE: Make sure the oil does not touch the counterbore or the liner flange and that the o-rings do not move from the grooves.