Engine Assembly (00-02) Cylinder Liners - Installation N14 Page 0-59 Liner installation tool, Part No. 3822953, is used to press the cylinder liner into the cylinder block. Protrusion can be checked while the liner is held down by the installation tool. Put a sealing ring into position on the counterbore ledge. Install the liner into the cylinder bore, slip through the sealing ring, and push down until it stops. Put the force plate (3) across the top of the liner with the step in the liner bore. Tap the top of the force plate with a soft hammer to square up and start the liner into the press fit bore.
Put the installation tool bridge (1) across the liner and install the two cylinder head capscrews finger tight to hold the bridge down. Rotate the force plate until the areas where the protrusion measurements will be taken are exposed. Caution: Do not use an impact wrench to tighten the liner force plate screw. Tighten the forcing screw (2). Torque Value: 136 [100 ft-lb] Check for correct protrusion.