Cummins — PISTON AND CONNECTING ROD ASSEMBLIES - ASSEMBLY AND INSTALLATION

Engine Assembly (00-02) Piston and Connecting Rod Assemblies - Assembly and Installation N14 Page 0-61 Piston and Connecting Rod Assem- blies - Assembly and Installation Install a new snap ring in one of the snap ring grooves of the piston pin bore on each piston. Heat the pistons in boiling water for 15 minutes or in an oven for 30 minutes at 100° C [212° F]. Use clean 15W-40 oil to lubricate the connecting rod piston pin bore and the piston pin. Caution: Use insulated gloves to prevent injury from the boiling water or the heated piston. Remove the piston from the water or the oven. Align the pin bore of the rod with the pin bore of the piston, and install the piston pin.

Do not use a hammer to install the piston pin. The piston will be damaged. NOTE: The cylinder number of the piston top (1) must be toward the bearing tang (2) side of the rod. Install a new snap ring in the second piston pin bore snap ring groove. The snap ring must be seated completely in the snap ring groove.