Piston and Connecting Rod Assemblies - Assembly and Installation Engine Assembly (00-02) N14 Page 0-62 The piston ring shipping package identifies the location of each piston ring by the part number. Install the rings in the sequence shown and in the proper orientation. The first and second rings have the word ‘‘TOP’’ stamped on the ring side facing the piston crown. The oil ring is not marked. NOTE: The oil control ring is symmetrical and can be in- stalled in either orientation. Caution: Do not over expand the piston rings. Maximum gap at assembly is 1.63 inches. Use piston ring expander, Part No.
3823871, to install the piston rings with the part number, mark, or the word toward the top of the piston. NOTE: The oil control ring is symmetrical and can be in- stalled in either orientation. A cross-sectioned view of an oil control ring is shown. The two-piece oil control ring must be installed with the ex- pander ring gap 180 degrees from the gap of the oil ring. Install the upper bearing shell in the connecting rod. If used bearing shells are to be installed, each bearing shell must be installed in its original location. NOTE: The tang (1) of the bearing shell must be in the slot (2) of the rod.