Engine Assembly (00-02) Piston and Connecting Rod Assemblies - Assembly and Installation N14 Page 0-63 Use clean Lubriplate T 105 or its equivalent to lubricate the bearing shell. Apply a heavy film of clean 15W-40 oil to the liner. Put the piston and the ring assembly in a container of clean 15W-40 oil. Remove the piston and the ring assembly from the con- tainer. Allow the excess oil to drain from the piston. Install connecting rod guide pins, Part No. 3375601. Use piston ring compressor, Part No. 3822736, to com- press the rings. Rotate the crankshaft to position the journal for the con- necting rod at bottom dead center (BDC). NOTE:
Use the barring tool and two capscrews to rotate the crankshaft.