Cummins — PISTON AND CONNECTING ROD ASSEMBLIES - ASSEMBLY AND INSTALLATION

Piston and Connecting Rod Assemblies - Assembly and Installation Engine Assembly (00-02) N14 Page 0-64 Caution: To avoid piston damage, do not use a metal object to push the piston in the liner. NOTE: The tang of the connecting rod must be toward the camshaft side of the cylinder block. The piston cooling noz- zles must be removed prior to installation of the piston and connecting rod assemblies. Caution: Do not use a hammer or equivalent to install the piston in the cylinder liner. The piston rings can be damaged. Install the connecting rod in the cylinder liner, and push the piston down. If the piston does not move freely, re- move the piston. Inspect for broken or damaged rings.

When installing the connecting rod, pay close attention to make sure the rod is aligned with the rod journal. If the rod is misaligned, it can bind or scrape the crankshaft connecting rod journal side walls. Use the guide pins to pull the connecting rod against the crankshaft. Remove the guide pins. Install the bearing in the connecting rod cap. NOTE: The tang (2) of the bearing must be in the slot (1) of the cap. Lubricate the bearing shell with Lubriplate T 105 or its equivalent. Lubricate the connecting rod capscrew threads and the washer face with 140W oil.