Cummins — REAR COVER - INSTALLATION

Engine Assembly (00-02) Rear Cover - Installation N14 Page 0-65 Caution: The rod cap alpha-numeric characters must match the alpha-numeric characters on the connecting rod and must be installed with the characters aligned to prevent damage to the connecting rods and the crank- shaft. The locking tang of the connecting rod cap must be toward the camshaft side of the cylinder block. Install the connecting rod caps and the capscrews. Tighten the rod capscrews in alternating sequence to the following torque values: Tighten to 102 [75 ft-lb]. Tighten to 264 [195 ft-lb]. Measure the connecting rod side clearance. The side clearance must be between 0.114 mm [0.0045-inch] and 0.51 mm [0.020-inch].

NOTE: The connecting rod must move freely from side to side on the crankshaft journal. If the rod does not move freely, remove the rod cap and make sure the bearing shells are the correct size. Check for dirt or damage on the crank- shaft and the bearing shells. Rear Cover - Installation Use a clean cloth to clean the crankshaft flange. NOTE: Do not use lubricant to install the seal. The oil seal must be installed with the lip of the seal and the crankshaft clean and dry to provide a correct oil sealing surface and to provide maximum engine life. Install a new gasket on the cylinder block. Install the rear cover and the eight capscrews and wash- ers.

Tighten the capscrews just enough to hold the rear cover in position.