Cummins — CRANKSHAFT SEAL, REAR - INSTALLATION

Crankshaft Seal, Rear - Installation Engine Assembly (00-02) N14 Page 0-66 Remove the pins from the crankshaft oil seal driver, Part No. ST-997; and use the driver to align the rear cover with the crankshaft. Install the seal drive in the crankshaft flange and in the bore of the rear cover. Tighten the rear cover mounting capscrews. Torque Value: 47 [35 ft-lb] Remove the crankshaft oil seal driver, Part No. ST-997. Use a gauge block, Part No. 3823495, to make sure the rear cover is within 0.10 mm [0.004-inch] of being parallel with the oil pan flange of the cylinder block.

Trim the excess gasket material from the ends of the rear cover gasket so the gasket is even or does not extend more than 0.25 mm [0.010-inch] beyond the pan flange. Crankshaft Seal, Rear - Installation Use the installation sleeve provided with the seal to install the seal on the crankshaft. NOTE: ‘‘LDL TFE’’ (Lay-down Lip, Teflon) oil seals for ser- vice replacement have an assembly tool which protects the seal lip during shipment and installation. The ‘‘LDL TFE’’ oil seal must be installed with the lip of the seal and the crank- shaft clean and dry. Do not use any kind of lubricant. The use of lubricant will result in oil leakage at the seal.

Push the oil seal over the installation sleeve onto the crankshaft, and remove the sleeve.