Cummins — FLYWHEEL HOUSING - INSTALLATION

Engine Assembly (00-02) Flywheel Housing - Installation N14 Page 0-67 Install the pins in crankshaft oil seal driver, Part No. ST-997. Use crankshaft oil seal driver, Part No. ST-997, to install the oil seal in the rear cover. Flywheel Housing - Installation Caution: If a new flywheel housing is being installed, the dowels must be removed from the cylinder block prior to installing the housing to prevent damage to the housing. The housing must be doweled with an oversize dowel after it has been aligned. Refer to Flywheel Hous- ing - Redowel to Cylinder Block (16-04). Install two 5/8-18 x 4-inch guide studs in the cylinder block to help support and align the housing during installation.

If a wet-type flywheel housing is being installed, do the following: 1. Install a new o-ring on the rear cover. Use vegetable oil to lubricate the o-ring. 2. Install 11 rectangular sealing rings in the capscrew dowel pin counterbores in the flywheel housing. Use gasket adhesive to fasten the sealing rings to the housing. Install the flywheel housing over the guide studs. Install the capscrews, and tighten in the sequence shown. Torque Value: 203 [150 ft-lb]