Flywheel Housing - Installation Engine Assembly (00-02) N14 Page 0-68 Bore Alignment - Measurement Caution: The flywheel housing bore and the surface must be in alignment with the crankshaft to prevent possible damage to the engine, the clutch, or the trans- mission. Use chalk to mark the housing at the 12:00 o’clock, 3:00 o’clock, 6:00 o’clock, and 9:00 o’clock positions. Use dial gauge indicator (1), Part No. 3376050, and dial gauge attachment (2), Part No. ST-1325, to measure the bore alignment. Attach a dial indicator to the crankshaft as shown. NOTE: The indicator arm must be rigid for an accurate reading. It must not sag. Put the indicator at the 12:00 o’clock position.
Adjust the dial indicator until the needle points to Rotate the crankshaft one complete revolution in a clock- wise direction (viewed from the front of the engine). Record the indicator reading at three different positions: 3:00 o’clock, 6:00 o’clock, and 9:00 o’clock. Continue rotating the crankshaft until the dial indicator is at the 12:00 o’clock position. Check the dial indicator to make sure the needle still points to