Flywheel Housing - Installation Engine Assembly (00-02) N14 Page 0-70 If the alignment is not within specifications and the bore is round, the housing can be shifted. Refer to Section 16. If the alignment is not within specifications and the bore is not round, the housing must be replaced. Face Alignment - Measurement Install the dial indicator as shown. Caution: The tip of the gauge must not enter the cap- screw holes or the gauge will be damaged. Put the tip of the dial indicator gauge against the flywheel housing surface. Rotate the crankshaft until the dial indicator is at the 12:00 o’clock position. Push the crankshaft toward the front of the engine.
Adjust the dial on the indicator until the needle points to NOTE: The crankshaft must be pushed toward the front of the engine to remove the crankshaft end clearance each time a point is measured. Rotate the crankshaft in a clockwise direction (viewed from the front of the engine). Record the indicator reading at three different positions: 3:00 o’clock, 6:00 o’clock, and 9:00 o’clock.