Cummins — FLYWHEEL - INSTALLATION

Flywheel - Installation Engine Assembly (00-02) N14 Page 0-72 If the alignment is not within specifications, remove the housing. Check for nicks, burrs, or foreign material be- tween the block and the housing. Check the alignment again. If the alignment is not within specifications, the block or the housing is not machined correctly. Flywheel - Installation NOTE: Use a new pilot bearing when installing a new or rebuilt clutch. Use a mandrel and a hammer to remove the pilot bearing. Use Scotch-Brite T 7448, Part No. 3823258, to clean the pilot bore. Use a mandrel and a hammer to install the pilot bearing. NOTE: The pilot bearing must be installed flush with the pilot bore surface.