Cummins — BORE ALIGNMENT - MEASUREMENT

Engine Assembly (00-02) Flywheel - Installation N14 Page 0-73 Install two t-bolts into the flywheel clutch mounting sur- face. Install two 5/8 - 18 x 6-inch guide studs in the crankshaft flange. Warning: Because this part weighs more than 23 kg [50 lbs], two people or a hoist will be required to lift the part to avoid personal injury. Install the flywheel on the guide stud. Caution: Do not use an anti-seize compound, penetrat- ing oil, or oil containing a friction modifier to lubricate the capscrews. This will result in incorrect capscrew torque and possible capscrew failure. Lubricate the threads of the capscrews and the surface of the washers with 15W-40 lubricating oil.

Install the four capscrews. Remove the t-bolts and the guide studs. Install the remaining two capscrews in the holes from which the guide studs were removed. Tighten the capscrews in a star pattern. Torque Value: 271 [200 ft-lb] Bore Alignment - Measurement Use dial indicator gauge (1), Part No. 3376050, or its equivalent and dial gauge attachment (2), Part No. ST- 1325, to inspect the flywheel bore (3) and the surface (4) runout. Install the attachment to the flywheel housing. Install the gauge on the attachment. Install the contact tip of the indicator against the inside diameter of the flywheel bore, and set the dial indicator to