Engine Assembly (00-02) Flywheel - Installation N14 Page 0-75 Install the flywheel, and inspect the bore runout again. Replace the flywheel if the runout does not meet specifications. Face Alignment - Measurement Install the contact tip of the indicator against the flywheel face, as close to the outside diameter as possible, to inspect the face (4) runout. Push the flywheel forward to remove the crankshaft end clearance. Adjust the dial on the indicator until the needle points to Rotate the crankshaft one complete revolution. Measure the flywheel runout at four equal points on the flywheel. NOTE:
The flywheel must be pushed toward the front of the engine to remove the crankshaft end clearance each time a point is measured.