Cummins — CYLINDER HEADS - INSTALLATION

Cylinder Heads - Installation Engine Assembly (00-02) N14 Page 0-76 The total indicator runout (T.I.R.) must not exceed the following specifications: Flywheel Radius (A) Maximum (T.I.R.) of Flywheel Face mm in mm in 203 8 0.203 0.008 254 10 0.254 0.010 305 12 0.305 0.012 356 14 0.356 0.014 406 16 0.406 0.016 If the flywheel face runout is not within specification, remove the flywheel. Check for nicks, burrs, or foreign material between the flywheel mounting surface and the crankshaft flange. Cylinder Heads - Installation Warning: Naptha and methyl ethyl ketone are flamma- ble materials. Use caution to prevent personal injury. Follow the manufacturer’s instructions.

Do not use start- ing fluid. Use a non-petroleum-based cleaner such as Part No. 3823717. Clean the cylinder head and the cylinder block head gasket contact surface. Install new gaskets on the dowel pins in the cylinder block. NOTE: Make sure the side of the gasket marked ‘‘TOP’’ is up.