Cummins — CYLINDER HEADS - INSTALLATION

Engine Assembly (00-02) Cylinder Heads - Installation N14 Page 0-77 Install the cylinder heads over the dowel pins. If reusing original cylinder heads, install them in their original position. Use clean 15W-40 oil to lubricate the cylinder head cap- screws and both sides of the flat washers. Allow the excess oil to drain from the threads. Install 12 capscrews and washers in each cylinder head. Complete the following steps to tighten the capscrews to the specified torque values in the sequence shown: Tighten to 136 [100 ft-lb]. Tighten to 298 [220 ft-lb]. Rotate 90 degrees, not less than one flat, and not more than two flats. Repeat the tightening sequence to install each cylinder head.

The markings on the head of the flange head capscrews serve as an aid during installation. After torquing the capscrew 298 [220 ft-lb], mark the cylinder head adjacent to one of the two single marks ‘‘A’’ or ‘‘B’’ on the capscrew head.