Cummins — CAMSHAFT INSTALLATION

Camshaft - Installation Engine Assembly (00-02) N14 Page 0-78 After all 12 capscrews on one head have been torqued to 298 N•m [220 ft-lb], they must be rotated in the tightening direction an additional 90 degrees. Rotate the capscrew until the mark on the cylinder head is between the next two marks joined by an arc (more than one flat and less than two flats). NOTE: When using torque plus angle, the tolerance on the 90 degree angle of rotation is one to two flats (90° plus or minus 30° ). If the capscrew is rotated beyond two flats, do not loosen the capscrew.

The clamp load is still acceptable; however, rotating the capscrew beyond two flats causes additional stretch and reduces the number of reuses. With proper torquing, the capscrew can typically be reused for the life of the engine. Camshaft - Installation Apply a film of Lubriplate T 105 or its equivalent to both sides of the camshaft thrust washer. Caution: The oil grooves on the thrust washer must be toward the camshaft gear to prevent thrust washer fail- ure. Install the thrust washer on the camshaft. Install four camshaft pilots, Part No. 3375268, over the base circle of the valve lobes between the camshaft jour- nals. Use a rubber band to hold the installation pilots in place.

The rubber band must straddle the valve lobes. Apply a film of Lubriplate T 105 or its equivalent to the camshaft journals and the camshaft bushings. Rotate the camshaft slowly as it is being installed in the cylinder block.