Engine Assembly (00-02) Camshaft - Installation N14 Page 0-79 Align the mark on the camshaft gear with the mark on the crankshaft gear. After aligning the marks, push the camshaft in the bore until the thrust washer fits against the cylinder block. Remove the camshaft installation pilots. Do not allow the rubber bands to fall into the camshaft cavity of the cyl- inder block when removing the installation pilots. Use a dial indicator to check the backlash between the camshaft gear and the crankshaft gear. Put the tip of the dial indicator against a tooth on the camshaft gear. Turn the camshaft gear by hand as far as it will freely move, and set the dial indicator at (zero).