2-38 CAB AND FRAME 7. Glass 9. Glass run Lower the glass to a position where the mount- ing screw can be seen, and remove the 4 screws. Pull out the glass run from the door frame groove. 10. Glass run rear channel Pull out the 2 mounting screws. N2A0069E N2A0071E Legend 1. Window regulator 2. Glass 3. Screw Legend 1. Power window motor connector 2. Glass run rear channel mounting screw 3. Mounting screw position Lower the front side of the glass. After the front side of the glass comes off from the glass run, pull up the rear side of the glass. Installation For installation, reverse the removal procedure taking the following points into consideration. 1.
Align the notch a of the glass run lip with the door outer waist line A. Align the glass run slit b with the door B and fit the glass run between A and B. Next, align the notch c of the glass run lip with the door outer waist line C and fit the glass run between B and C. Fit the glass run in the channel within the door. (Refer to the illustration shown on the next.) N2A0070E Legend 1. Glass run 8. Window regulator Disconnect the harness connector of the power window motor and remove the 5 mounting screws.