2-8 CAB AND FRAME 1. Front window glass finisher (1) Be sure to use a new one. Apply the primer to the whole periphery of body side. Caution: Check that there remains no adhesive on the flange sur- face to which the primer is to be applied. If the primer is applied on the residual adhesive, the contact of the ad- hesive for glass to be applied later may be imperfect, re- sulting in cracks or water leakage. After applying the primer, keep the status for 3 minutes or more. Primer: PRIMER RC-50E for painting manufac- tured by The Yokohama Rubber Co., Ltd.
or equiv- alent Mounting/Dismounting Procedure for Ornament Panel First, remove the washer nozzle (refer to Section 8 “Electrical Equipment Workshop Manual”), cut off the two-sided adhesive tape fixing the ornament panel with a cutter and remove it from the front panel. At this time, don’t bend the ornament panel over 90 ° . Take care not to scratch the painted sur- face of the body panel. If it is scratched, repair it completely to prevent rust. When installing the or- nament panel, completely remove the two-sided adhesive tape remaining on the ornament panel side and install the ornament panel with a new two- sided adhesive tape. N2A0020E 2.
Front window molding (5) Align the paint marking part of the back side of molding with the alignment mark (7) on the glass ceramic painting part (6), insert the upper ends (left and right) and fix the both sides. Be sure to use a new one. The margin (8) of molding should be equal at both ends. Caution: After removing the washer nozzle, take care not to drop the washer tube to the inside of the front panel. After removing the ornament panel, connect the nozzle to the tube and fix it. N2A0021E N2A0223E