CAB AND FRAME 2-9 Adhesive: ADHESIVE WS-90F for glass manufac- tured by The Yokohama Rubber Co., Ltd. or equiv- alent Caution: Install the glass on the cab within 5 minutes after apply- ing the adhesive. At this time, peel off the exfoliate paper of the two-sided adhesive tape of front window glass fin- isher and set the glass by pressing accurately at the in- stallation position determined in the positioning procedure described on the previous step. Harden the adhesive at temperature of 20 to 30 ° C for 24 hours. Press the periphery by using a gummed tape as an aux- iliary means. Imperfect press fitting will cause water leakage. N2A0022E 3.
Front window glass (9) Apply the primer (10) to the outer periphery on the room side of the glass. Apply it over 20 mm from the end. Caution: Before reusing the glass, completely remove the residu- al adhesive and perform cleaning. If the primer is ap- plied on the residual adhesive, the contact of the adhesive for glass to be applied later may be imperfect, resulting in cracks or water leakage. After applying the primer, keep the status for 3 minutes or more. Primer: PRIMER MS-80 for both sides of glass manufactured by The Yokohama Rubber Co., Ltd. or equivalent N2A0024E 4. Front pillar grip/trim cover For the grip, be sure to use the specified bolt.
Be sure to use a new two-sided adhesive tape for the trim cover. Caution: Take care not to push the glass from the inside of the room at installation. 5. Ornament panel upper molding 6. Outside mirror assembly/outside mirror attach- ment/molding Be sure to use a new two-sided tape for mold- ing. 7. Outside mirror stay cap/front panel side/sub cover 8. Clearance lamp Refer to “Outside Mirror Assembly” in this Sec- tion. 9. Front wiper arm 10. Room mirror stopper rubber N2A0023E After keeping the status for 3 minutes or more after primer application, apply the adhesive. Apply it to the whole outer periphery and make a 30 mm lap allowance.
Install this rubber after adhesive for the front window glass becomes completely hard.