Electronic control fuel injection system (Common rail type) 1E-107 Boost temperature sensor Note: Refer to the machine’s manual for the locations of diagnosis lamp. DLC (data link connector) 8 7 6 5 4 3 2 1 16 15 14 13 12 11 10 9 The boost temperature sensor is installed onto the EGR valve upstream side of intake manifold. The sensor is thermistor type. The resistance in the sensor changes as the temperature changes. TSWG0023 The DLC (data link connector) is a connector for communication and connection between the external diagnostic device (scan tool) and each controller. Removal Disconnect the connector and remove it with 19mm-wrench Note:
Refer to the machine’s manual for the locations of DLC. Diagnostic switch The diagnosis switch shorts the DLC terminals No. 1 and No. 4 (or No. 5) to make the diagnosis lamp blink to indicate DTC. Note: Refer to the machine’s manual for the locations and form of diagnosis switch. 19mm Memory clear switch The diagnosis switch and memory clear switch are used to clear the DTC stored in ECM. Note: Refer to the machine’s manual for the locations of memory clear switch. Installation TSWG0187 Tightening torque: 10.8 — 16.3 N m {1.1 — 1.7 kg m/96 — 144 lb in} Mode selector switch (1, 2, 3) The mode selector switch allows to operate at the engine speed set by each mode.
Diagnosis lamp It indicates DTC by blinking after the diagnosis switch is turned to ON. Note: Refer to the machine’s manual for the locations of mode selector switch.