1E-106 Electronic control fuel injection system (Common rail type) Removal Boost pressure sensor Disconnect the connector, and remove the six 12mm-mounting bolts and EGR valve. TSWG0022 TSWG0193 The boost pressure sensor uses the pressure hose between the boost pressure sensor and intake pipe, detects boost (intake air pressure), converts the pressure into the voltage signal and sends it to engine control module (ECM). Voltage becomes higher as pressure becomes higher, and lower as one does lower. ECM calculates the boost (intake air pressure) based on the voltage signal sent from sensors and uses it for fuel injection control etc.
Removal Disconnect the connector, and remove the two 10mm-mounting bolts, hoses and sensor. 10mm TSWG0196 Installation TSWG0188 Tightening torque: 4 — 6 N m {0.4 — 0.6 kg m/35 — 53 lb ft}