hitachi — EGR position sensor

Electronic control fuel injection system (Common rail type) 1E-105 Accelerator position (AP) sensor Intake air temperature (IAT) sensor The accelerator position (AP) sensor is installed onto machine console panel and supplies the voltage signal, which changes according to the accelerator volume angle, to engine control module (ECM). The ECM calculates accelerator position by voltage signal and use it for various controls such as fuel injection amount control. Note: Refer to the machine’s manual for the location of accelerator position sensor.

Barometric pressure sensor The intake air temperature (IAT) sensor is installed onto the machine side and detects the temperature of intake air for optimum fuel injection control. Tightening torque: 10.8 — 16.3 N m {1.1 — 1.7 kg m/96 — 144 lb in} Note: Refer to the machine’s manual for the location of intake air temperature (IAT) sensor. EGR position sensor TSWG0020 The barometric pressure sensor is installed onto the machine side and converts the barometric pressure into voltage signal. The ECM calculates barometric pressure by voltage signal and performs fuel injection amount correction (high-altitude correction) etc. by barometric pressure. Note:

Refer to the machine’s manual for the location of barometric pressure sensor. It is installed in EGR valve and detects the valve lift amount of EGR. TSWG0149 Note: Do not disassemble the EGR position sensor. If it is faulty, replace it as EGR valve ASM.