1E-104 Electronic control fuel injection system (Common rail type) Crankshaft position (CKP) sensor Engine oil pressure sensor TSWG0019 TSWG0067 The crankshaft position (CKP) sensor is installed onto flywheel housing and produces the CKP signal when the convex portion of flywheel passes the sensor. The engine control module (ECM) distinguishes the cylinders by the G signal input from G sensor, determines the crank angle and uses it to control fuel injection and calculate the engine speed. These controls is performed, usually based on CKP signal. However it is done by G sensor if the CKP sensor is faulty.
The engine oil pressure sensor is installed near the starter motor of the cylinder block; it detects engine oil pressure, converts the pressure into the voltage signal and sends it to engine control module (ECM). Voltage becomes higher as pressure becomes higher, and lower as one does lower. Removal Disconnect the connector, and remove the 27mm- mounting bolt and sensor. (Lock position of the connector is the lower side) Removal Disconnect the connector, and remove the 10mm- mounting bolt and sensor. 10mm TSWG0192 Installation TSHK0123 Tightening torque: 41 N m{4.2 kg m/30 lb ft} Installation Tightening torque: 14.7 — 24.5 N m {1.5 — 2.5 kg m/11 — 18lb ft}