hitachi — Engine coolant temperature (ECT) sensor

Electronic control fuel injection system (Common rail type) 1E-103 Injector The engine coolant temperature (ECT) sensor is installed onto engine block, and the thermistor changes the resistance according to the temperature. Resistance is low at high engine coolant temperature and high at low engine coolant temperature. The engine control module (ECM) energizes the voltage (5 V) to the ECT sensor through pull up resistance, and calculates engine coolant temperature based on change of voltage to use for various controls such as fuel injection etc. If the resistance is low (temperature is high), the voltage becomes low; if the resistance is high (temperature is low), the voltage becomes high.

Removal Disconnect the connector and remove it with 19mm-wrench TSWG0016 The injector is installed onto cylinder head section and is controlled by engine control module (ECM) to inject fuel. The ECM raises the voltage for operating injectors internally, energizes to injector, and regulates period of electric conduction of injector to control fuel injection amount and injection timing. 19mm Note: For work procedure, refer to “Engine section” in the service manual. Engine coolant temperature (ECT) sensor TSWG0186 Installation Apply Loctite 572 before installing it. Tightening torque: 19.6 — 29.4 N m {2 — 3 kg m/ 14 — 22 lb ft} TSWG0017