hitachi — List of function checks

Electronic control fuel injection system (Common rail type) 1E-135 List of function checks In the subsequent part of this manual, “scan tool” indicates scan tools including Tech2. Interview Inspection to comprehend the trouble symptom and diagnose properly based on a customer’s complaint. OBD system check Inspection to identify defective point of engine control system (inspection procedure) Diagnosis lamp illumination circuit system check Inspection when diagnosis lamp does not come on when starter switch is turned ON. Diagnosis lamp blinking circuit system check Inspection when diagnosis lamp does not blink (remains on) when diagnostic switch is turned ON.

Scan tool power supply circuit system check Inspection when scan tool (Tech2) does not operate. Scan tool communication circuit system check Inspection when scan tool (Tech2) cannot communicate with ECM. Starting circuit system check Inspection when starter does not operate. Starting system check Inspection when starter operates but engine does not start. Fuel system check Inspection when relevant points to fuel system may be faulty (inspection procedure). Intake system check Inspection when relevant points to intake system may be faulty (inspection procedure). Exhaust system check Inspection when relevant points to exhaust system may be faulty (inspection procedure).

EGR control system check Inspection when relevant points to EGR may be faulty (inspection procedure). QOS control system check Inspection when relevant points to QOS (glow) may be faulty (inspection procedure). CAN communication check Inspection when fault relevant to machine control unit and CAN communication between scan tool and ECM may exist. Machine-side check Inspection when fault relevant to machine function (inspection procedure) may exist.