hitachi — OBD system check

1E-136 Electronic control fuel injection system (Common rail type) OBD system check About OBD system check Note for OBD system check OBD system check is systematic method to check the problems which caused by engine control system malfunction. It is the first procedure of all complaint diagnosis for operationality. Use of this diagnostic step properly enables to shorten the diagnosis period and to prevent unnecessary replacement of proper parts. Important: If there is no complaint for operationality, never perform this diagnostic step unless otherwise instructed in other items. Before the diagnosis, check the service information.

Never erase DTCs unless otherwise instructed in the diagnostic step. If fault is found in the engine starting system, refer to “Electrical system” in the service manual “Engine section”. Ensure the battery is fully charged. Make sure the battery cable is normal and securely connected. Make sure the ground cable of ECM is connected to the proper position securely. Test description 5. Communication disability with scan tool is caused by fault in the communication circuit between each ECU and scan tool. 8. If DTC is detected, proceed to the relevant DTC diagnosis by referring to the list of DTC.

If more than one DTC is detected, start with the one with smallest DTC number unless otherwise instructed in the diagnostic step. Step Action Value YES NO 1 1. Turn the key switch to “ON”. 2. Check the diagnosis lamp (trouble display monitor on the machine). Does the diagnosis lamp (trouble display monitor on the machine) come on? — Go to Step 2. Go to Step 2 in “Diagnosis lamp illumination circuit system check”. 2 1. Connect the diagnosis connector. • If the machine is not equipped with diagnosis lamp, go to Step 3. 2. Check the diagnosis lamp. Does the diagnosis lamp blink? — Go to Step 3. Go to Step 2 in “Diagnosis lamp blinking circuit system check”.

3 Is the scan tool (KW communication) available? — Go to Step 4. Go to Step 6. 4 1. Connect the scan tool. 2. Turn the key switch to “ON”. 3. Turn the power switch of the scan tool to “ON”. Does the scan tool powered “ON”? — Go to Step 5. Go to “Scan tool power supply circuit system check”. 5 Communicate with ECM using scan tool. Does it communicate with ECM properly? — Go to Step 6. Go to Step 2 in “Scan tool communication circuit system check”. 6 Turn the key switch to “START”. Does the starter operate? — Go to Step 7. Go to “Starting circuit system check”. 7 Turn the key switch to “START”. Does the engine start? — Go to Step 8. Go to “Starting system check”. 8 Check if DTC is detected.

Is DTC detected? — Go to the relevant DTC diagnosis. Go to Step 9.