1E-138 Electronic control fuel injection system (Common rail type) Diagnosis lamp illumination circuit system check (*: Specifications (fuse current value etc.) vary depending on each machine.
Refer to the machine manual.) (15A)* A A Machine trouble diagnosis monitor Meter Tachometer Diagnosis lamp Engine oil pressure lamp QOS indicator lamp Boost temperature lamp Machine control unit CAN HIGH CAN LOW Engine control module (ECM) 37 E-57 18 E-57 6 E-57 8 E-57 17 E-57 11 E-57 7 E-57 Diagnosis lamp control Engine oil pressure lamp control QOS indicator lamp control Boost temperature lamp control CAN HIGH CAN LOW Tachometer signal TSWG0075 Description of circuit Following inspections are necessary to detect these causes. Improper connection of harness connector and ECM connector Poor connection of terminal from connector Unmatched terminals are fitted.
Damage of connector lock Poor contact between terminal and wire Damaged harness Visually check the harness for damage. Check the relevant items on the scan tool data display while moving the connector and the harness which are related to the sensor. The variation of the display indicates the faulty part. The power supply voltage is supplied to the diagnosis lamp via key switch, and the signal from ECM will turn the lamp on. The ECM turns the diagnosis lamp on during lamp check with the key switch “ON” and when DTC is detected. Also when the diagnosis connector is connected, it blinks the diagnosis lamp according to the DTC detected.
A monitor circuit is provided inside the ECM to monitor the lamp operation. Diagnostic aid If the intermittent trouble is suspected, followings may be the cause. Improper connection of harness connector Defective harness routing Worn harness cladding Wire disconnection inside harness cladding