Electronic control fuel injection system (Common rail type) 1E-139 Step Action Value YES NO 1 1. Turn the key switch to “ON”. 2. Check the diagnosis lamp. Does the diagnosis lamp come on? — Go to “Diagnostic aid”. Go to Step 2. 2 Remove the diagnosis lamp to check its condition. Is the trouble detected? — Replace the diagnosis lamp. Go to Step 3. 3 Check for open/short circuit between the diagnosis lamp and ECM and power supply circuit using DMM. Is the trouble detected? — Repair the harness. Go to Step 4. 4 Is EMPS available? — Go to Step 5. Go to Step 6. 5 1. Check the version of ECM software. 2. Rewrite the software if version upgraded is necessary.
Refer to “How to use flash tool” in this section for check and rewriting of ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Check the repair, and Go to “OBD system check”. — 6 Replace the ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Check the repair, and Go to “OBD system check”. —