1E-140 Electronic control fuel injection system (Common rail type) Diagnosis lamp blinking circuit system check CAN HIGH CAN LOW Engine control module (ECM) KWP2000 52 E-57 38 E-57 37 E-57 4 E-57 3 E-57 1 E-57 43 E-57 62 E-57 81 E-57 18 E-57 6 FL-150 7 FL-150 DLC 4 FL-150 5 FL-150 Machine control unit CAN HIGH CAN LOW TSWG0074 Description of circuit Following inspections are necessary to detect these causes. Improper connection of harness connector and ECM connector Poor connection of terminal from connector Unmatched terminals are fitted. Damage of connector lock Poor contact between terminal and wire Damaged harness Visually check the harness for damage.
Check the relevant items on the scan tool data display while moving the connector and the harness which are related to the sensor. The variation of the display indicates the faulty part. The power supply voltage is supplied to the diagnosis lamp via key switch, and the signal from ECM will turn the lamp on. The ECM turns the diagnosis lamp on during lamp check with the key switch “ON” and when DTC is detected. Also when the diagnosis connector is connected, it blinks the diagnosis lamp according to the DTC detected. A monitor circuit is provided inside the ECM to monitor the lamp operation. Diagnostic aid If the intermittent trouble is suspected, followings may be the cause.
Improper connection of harness connector Defective harness routing Worn harness cladding Wire disconnection inside harness cladding