hitachi — Diagnosis lamp blinking circuit system check

Electronic control fuel injection system (Common rail type) 1E-141 Step Action Value YES NO 1 1. Turn the key switch to “OFF”. 2. Connect the DMM between the diagnosis connector (male-side) and the ground. 3. Turn the key switch to “ON”. Is the DMM indication more than the specified value? 0V Go to Step 2. Go to Step 3. 2 Check for installation condition of the ECM connector and coupling connector. 1. Check for play or looseness in the connection. 2. If the trouble is detected, repair as required. Is the trouble detected? — Verify repair. Go to Step 3. 3 1. Check for followings in the circuit between ECM and diagnosis connector using breaker box or DMM.

Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Open circuit • High resistance 2. If the trouble is detected, repair as required. Is the trouble detected? — Verify repair. Go to Step 4. 4 1. Check for following in the circuit between diagnosis connector and ground. • Open circuit • High resistance 2. If the trouble is detected, repair as required. Is the trouble detected? — Verify repair. Go to Step 5. 5 Check the diagnosis lamp blinking condition again. 1. Turn the key switch to “ON”. 2. Connect the diagnosis connector. 3. Check the diagnosis lamp. Does the diagnosis lamp blink? — Go to “Diagnostic aid”.

Go to Step 6. 6 Is EMPS available? — Go to Step 7. Go to Step 8.