hitachi — Scan tool communication circuit system check

Electronic control fuel injection system (Common rail type) 1E-147 Breaker box inspection procedure Perform the inspection in the following procedure if there is such an instruction to use breaker box in the step. After inspection, return to the diagnostic step. Name 1. Breaker box 2. DMM Step Action Value YES NO 8 Replace the ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 9. — 9 1. Connect the scan tool. 2. Turn the key switch to “ON”. 3. Communicate with ECM using scan tool.

Does it communicate with ECM properly? — Verify repair. Go to Step 2. Step Item to be checked Inspection method Measuring condition Terminal No. Normal value Abnormal value 4 Open circuit/ high resistance Resistance measurement • Key switch “OFF” 38 - DLC terminal No. 7 100Ω or less 10 MΩ or more Short circuit to ground Resistance measurement • Key switch “OFF” 38 - Ground 10 MΩ or more 100Ω or less