hitachi — Scan tool communication circuit system check

1E-146 Electronic control fuel injection system (Common rail type) Step Action Value YES NO 1 Perform the OBD system check. Is the procedure completed? — Go to Step 2. Go to “OBD system check”. 2 Check for installation condition of the ECM connector and coupling connector. 1. Check for play or looseness in the connection. 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 9. Go to Step 3. 3 1. Check the DLC for following conditions. • Poor connection of terminal from connector • Poor contact between terminal and wire 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 9. Go to Step 4. 4 1.

Check for followings in the circuit between ECM and DLC using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Open circuit • High resistance • Short circuit to ground 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 9. Go to Step 5. 5 1. Connect the scan tool. 2. Turn the key switch to “ON”. 3. Communicate with ECM using scan tool. Does it communicate with ECM properly? — Go to “Diagnostic aid”. Go to Step 6. 6 Is EMPS available? — Go to Step 7. Go to Step 8. 7 1. Check the version of ECM software. 2.

Rewrite the software if version upgraded is necessary. Refer to “How to use flash tool” in this section for check and rewriting of ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 9. Go to Step 8.