hitachi — Starting circuit system check

1E-152 Electronic control fuel injection system (Common rail type) Breaker box inspection procedure Name 1. Breaker box 2. DMM Perform the inspection in the following procedure if there is such an instruction to use breaker box in the step. After inspection, return to the diagnostic step. Step Action Value YES NO 16 1. Check for followings in the circuit between key switch and ECM using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Open circuit • High resistance 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 12. Go to Step 17. 17 1.

Turn the key switch to “OFF”. 2. Remove the starter cut relay. 3. Check for continuity between the starter cut relay switch-side terminals. Is the trouble detected? — Go to Step 18. Go to Step 19. 18 Replace the starter cut relay. Is the procedure completed? — Go to Step 12. — 19 1. Turn the key switch to “OFF”. 2. Remove the starter relay. 3. Connect the battery to the starter relay coil-side terminal. 4. Check for continuity between the starter relay switch-side terminals. Is the trouble detected? — Go to Step 8. Go to Step 9.