hitachi — Starting circuit system check

Electronic control fuel injection system (Common rail type) 1E-151 Step Action Value YES NO 9 Turn the key switch to “START”. Does the starter operate? — Go to “Diagnostic aid”. Go to Step 10. 10 1. Check the following circuits for open circuit or high resistance. • Between key switch and starter cut relay • Between starter cut relay and starter relay • Between starter relay and ground • Between starter relay and starter 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 15. Go to Step 11. 11 1. Inspect by referring to “Electrical system” in the service manual “Engine section” 2. If the trouble is detected, repair as required. Is the trouble detected?

— Go to Step 15. Go to Step 12. 12 Is EMPS available? — Go to Step 13. Go to Step 14. 13 1. Check the version of ECM software. 2. Rewrite the software if version upgraded is necessary. Refer to “How to use flash tool” in this section for check and rewriting of ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 15. Go to Step 14. 14 Replace the ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM.

Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 15. — 15 Turn the key switch to “START”. Does the starter operate? — Check the repair, and Go to “OBD system check”. Go to Step 1.