1E-150 Electronic control fuel injection system (Common rail type) Test description Numbers below indicate step numbers in the diagnostic chart. 1. If these DTCs are detected, engine may not start. 3. When the ECM does not recognize the “START” position signal from the key switch, the starter cut relay is set “OFF”. Therefore, the starter relay will not turn Step Action Value YES NO 1 1. Turn the key switch to “ON”. 2. Check the DTC. Is the DTC P0340, P0341, P0615, P1345 or P1625 detected? — Go to the relevant diagnosis of DTC detected. Go to Step 2. 2 Is the scan tool available? — Go to Step 3. Go to Step 16. 3 1. Turn the key switch to “START”. 2.
Check for “Starter switch (ST)” on the data display using scan tool. Is the “Starter switch (ST)” displayed “ON”? — Go to Step 5. Go to Step 4. 4 1. Check for followings in the circuit between key switch and ECM using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Open circuit • High resistance 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 12. Go to Step 11. 5 1. Turn the key switch to “OFF”. 2. Remove the starter cut relay. 3. Check for continuity between the starter cut relay switch-side terminals. Is the trouble detected? — Go to Step 6.
Go to Step 7. 6 Replace the starter cut relay. Is the procedure completed? — Go to Step 12. — 7 1. Turn the key switch to “OFF”. 2. Remove the starter relay. 3. Connect the battery to the starter relay coil-side terminal. 4. Check for continuity between the starter relay switch-side terminals. Is the trouble detected? — Go to Step 8. Go to Step 9. 8 Replace the starter relay. Is the procedure completed? — Go to Step 12. —