Electronic control fuel injection system (Common rail type) 1E-163 Step Action Value YES NO 3 1. Start the engine. 2. Warm-up the engine until the engine coolant temperature is 70°C (158°F). 3. Check the value for “EGR position” using scan tool. Is “EGR position” within the specified value? ±3% Normal system Go to Step 4. 4 1. Perform “EGR control test” using scan tool. 2. Press the “Up” “Down” soft key. 3. Check the value for “EGR position”. Is “EGR position” within the specified value? ±3% Go to Step 6. Go to Step 5. 5 Replace the EGR valve. After replacing the EGR valve or ECM, the EGR valve position learning must be performed in the following procedure. 1. Turn the key switch to “ON”. 2.
Turn the key switch to “OFF”. 3. Leave as it is for 10 seconds. Failure to perform above procedure may result in detection of DTC for EGR. Is the procedure completed? — Go to Step 6. — 6 1. Check for damage or gas leakage in the EGR pipe. 2. If the trouble is detected, repair as required. Is the procedure completed? — Go to Step 7. — 7 1. Start the engine. 2. Warm-up the engine until the engine coolant temperature is 70°C (158°F). 3. Check the value for “EGR position” using scan tool. Is “EGR position” within the specified value? ±3% Verify repair. Go to Step 3. 8 1. Remove the EGR valve. 2. Check the EGR valve for anchoring, clogging, etc. 3. If the trouble is detected, repair as required.
Is the trouble detected? — Go to Step 9. Normal system 9 Replace the EGR valve. After replacing the EGR valve or ECM, the EGR valve position learning must be performed in the following procedure. 1. Turn the key switch to “ON”. 2. Turn the key switch to “OFF”. 3. Leave as it is for 10 seconds. Failure to perform above procedure may result in detection of DTC for EGR. Is the procedure completed? — Go to Step 10. —