1E-182 Electronic control fuel injection system (Common rail type) About recovery from failure *2 When the DTC has recovered to normal condition in the ignition cycle that the DTC is detected, the diagnosis lamp and back up mode will also be recovered. There are three modes for recovery from failure. To clear the trouble displayed on the monitor of the machine, one more ignition cycle may be needed after the following ignition cycle. 1 2 *1 Even if the DTC has restored normally, the diagnosis lamp and back-up mode are not restored in the ignition cycle that the DTC is detected. After turning the key switch OFF, DTC diagnosis is performed when the vehicle starts again.
If it is judged as normal, everything will be recovered to normal from the next ignition cycle. Key switch and Engine run ON OFF Diag lamp ON 1 2 3 OFF Key switch and Engine run ON ON OFF Back-up mode OFF Diag lamp ON Name 1. DTC is detected. 2. Recovery to normal. TSWG0166 OFF Back-up mode ON *3 When the DTC has recovered to normal in the ignition cycle that the DTC is detected, the back-up mode will be recovered normally, but the diagnosis lamp does not go off. OFF TSWG0165 Name 1. DTC is detected. 2. Repair and inspection 3. Returned to normal. 1 2 Key switch and Enigne run ON OFF Diag lamp ON OFF ON Back-up mode OFF Name 1. DTC is detected. 2. Recovery to normal. TSWG0207