Electronic control fuel injection system (Common rail type) 1E-185 DTC set condition Back-up mode 1st step Rail pressure is more than 150 MPa (21756 psi) for 5 seconds or more. Common rail pressure sensor voltage is 3.9 V or more. 2nd step 1st stage is completed, and rail pressure is more than 155 MPa (22481 psi) for 5 seconds or more. Common rail pressure sensor voltage is 4.0 V or more. Limited injection amount 3 (multi-injection stopped) target RP upper limit (80 MPa {11603 psi}) Recovery from failure Refer to “List of diagnostic trouble code” and “About recovery from failure” in this section for recovery from failure.
The conditions to clear the MIL/DTC The present trouble turns to history trouble when the condition is out of the range from DTC set condition (recovery from failure). The diagnosis lamp will go off after the code turns to history trouble and the key switch is turned “OFF” then “ON” again. Using the scan tool, or memory clear switch and diagnostic switch operation enables to clear DTCs. Note: Pressure limiter opens at 200 MPa (29008 psi), and DTC P1095 is detected in this case. Common rail presure Diagnostic aid If the intermittent trouble is suspected, followings may be the cause.
Improper connection of harness connector Defective harness routing Worn harness cladding Wire disconnection inside harness cladding Following inspections are necessary to detect these causes. Improper connection of harness connector and ECM connector Poor connection of terminal from connector Unmatched terminals are fitted. Damage of connector lock Poor contact between terminal and wire Damaged harness Visually check the harness for damage. Check the relevant items on the scan tool data display while moving the connector and the harness which are related to the sensor. The variation of the display indicates the faulty part.
T>1sec=P1095 200 MPa (29008psi) 155 MPa (22481psi) 150 MPa (21756psi) T T T>5sec=P0088 TSWG0179 Action taken when DTC is set Trouble is displayed on the monitor of the machine or diagnosis lamp comes on. Step Action Value YES NO 1 Perform the OBD system check. Is the procedure completed? — Go to Step 2. Go to “OBD system check”. 2 1. Start the engine. 2. Check the DTC. 3. Are the fuel-related parts only just replaced? Air bleeding may not be performed sufficiently after replacing fuel-related parts. Bleed air again. Check the DTC after bleeding air. Is any of the P0088, P0192, P0193, or P1635 detected? — Go to the relevant DTC detected. Go to Step 3.