1E-186 Electronic control fuel injection system (Common rail type) Step Action Value YES NO 3 Is the scan tool (KW communication) available? — Go to Step 4. Go to Step 5. 4 1. Turn the key switch to “OFF” for more than 30 seconds. 2. Start the engine. 3. Check for “Differential fuel rail pressure” on the data display using scan tool. Is “Differential fuel rail pressure” within the specified value? Differential pressure ±5 MPa (±725 psi) (at idle) Go to Step 5. Go to “Diagnostic aid”. 5 1. Check the fuel return pipe between the supply pump and the fuel tank for breakage, twist, etc. 2. Check for clogging or twisting in the vent hose of the fuel tank. 3.
Check for foreign matter in the fuel tank. 4. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 8. Go to Step 6. 6 1. Replace the common rail (common rail pressure sensor) since it seems that abnormal value of the pressure sensor is detected. Note: For work procedure, refer to “Engine section” in the service manual. 2. Check the DTC. Is the trouble detected? — Go to Step 7. Go to Step 8. 7 Replace the supply pump. Note: For work procedure, refer to “Engine section” in the service manual. Is the procedure completed? — Go to Step 8. — 8 Check the DTC again. 1. Connect all the harnesses. 2. Clear the DTC.
Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 3. Turn the key switch to “OFF” for more than 10 seconds. 4. Test run with the “Preconditions when DTC is set”. 5. Check the DTC. Is DTC P0088 detected? — Go to Step 2. Go to Step 9. 9 Check if other DTC is detected. Is other DTC detected? — Go to each DTC diagnosis. Verify repair.