Electronic control fuel injection system (Common rail type) 1E-189 EGR position sensor signal Common rail pressure sensor signal G sensor signal EGR position sensor signal EGR position sensor signal 5V Engine control module (ECM) B+ B+ B+ 98 E-56 101 E-56 82 E-56 100 E-56 90 E-56 87 E-56 92 E-56 110 E-56 93 E-56 103 E-56 94 E-56 111 E-56 5 H-20 H-20 H-20 H-20 H-20 H-8 H-8 H-8 H-8 H-8 H-8 14 6 13 12 3 7 2 6 1 5 0.5 Br 0.5 L/W 0.5 L 0.75 L 0.75 GY 0.75 W/L 0.75 G/W 0.75 W/B 0.75 G/B 0.75 W/R 0.75 L/W 1 E-80 2 E-80 6 E-80 3 E-80 7 E-80 4 E-80 8 E-80 5 E-80 0.5 L/W 0.75 B/W 0.5 L 0.5 Br 1 E-112 2 E-112 3 E-112 1 E-113 3 E-113 2 E-113 W V U EGR position sensor/EGR motor Common rail pressure sensor G sensor EGR valve TSWG0080 Description of circuit The common rail pressure sensor detects the common rail internal pressure.
The common rail pressure sensor is installed to the common rail. As the common rail internal pressure changes depending on engine condition, output voltage of the common rail pressure sensor will change (if the common rail internal fuel pressure is low, output voltage becomes low, if the pressure is high, the output voltage becomes high as well). The engine control module (ECM) reads this output voltage change, converting it into common rail internal pressure, to utilize for control. Dedicated communication circuits are used for the sensor power supply (5V), SIG, and ground in the common rail pressure sensor, which are connected to the ECM.
Also, the sensor circuit is shielded to avoid electrical noise etc. Rough idling Output lowering Engine blow up fault Black smoke emitted Excessive output possible Preconditions when DTC is set Key switch input voltage is 16V or more. DTC P0089, P0192, P0193, or P1635 is not detected. Coolant temperature is 60 ° C (140 ° F), and 375 rpm or more. DTC set condition Actual rail pressure higher than target rail pressure for 10 MPa (1450 psi) or more holds 8 seconds or more. Main trouble symptom Intense engine vibration