hitachi — DTC: P0089 (Flash code 151) Common rail pressure fault (Excessive pressure feed in supply pump)

1E-190 Electronic control fuel injection system (Common rail type) Actual rail pressure higher than target rail pressure for 10 MPa (1450 psi) or more holds 8 seconds or more during indication of no pressure feed. Using the scan tool, or memory clear switch and diagnostic switch operation enables to clear DTCs. Diagnostic aid Action taken when DTC is set Trouble is displayed on the monitor of the machine or diagnosis lamp comes on. If the intermittent trouble is suspected, followings may be the cause. Improper connection of harness connector Defective harness routing Worn harness cladding Wire disconnection inside harness cladding Following inspections are necessary to detect these causes.

Improper connection of harness connector and ECM connector Poor connection of terminal from connector Unmatched terminals are fitted. Damage of connector lock Poor contact between terminal and wire Damaged harness Visually check the harness for damage. Check the relevant items on the scan tool data display while moving the connector and the harness which are related to the sensor. The variation of the display indicates the faulty part. Back-up mode Limited injection amount 3 (multi-injection stopped) target RP upper limit (80 MPa {11603 psi}) Recovery from failure Refer to “List of diagnostic trouble code” and “About recovery from failure” in this section for recovery from failure.

The conditions to clear the MIL/DTC The present trouble turns to history trouble when the condition is out of the range from DTC set condition (recovery from failure). The diagnosis lamp will go off after the code turns to history trouble and the key switch is turned “OFF” then “ON” again. Step Action Value YES NO 1 Perform the OBD system check. Is the procedure completed? — Go to Step 2. Go to “OBD system check”. 2 1. Start the engine. 2. Check the DTC. Is any of the P0089, P0192, P0193, or 1635 detected? — Go to the relevant DTC detected. Go to Step 3. 3 Is the scan tool (KW communication) available? — Go to Step 4. Go to Step 12. 4 1. Turn the key switch to “OFF” for more than 30 seconds.

2. Start the engine. 3. Check for “Differential fuel rail pressure” on the data display using scan tool. Is “Differential fuel rail pressure” within the specified value? Differential pressure ±5 MPa (±725 psi) Go to “Diagnostic aid”. Go to Step 5. 5 1. Turn the key switch to “OFF”. 2. Wait for 2 minutes before the common rail internal pressure goes down. 3. Turn the key switch to “ON”. Do not start engine. 4. Check for “Differential fuel rail pressure” on the data display using scan tool. Is “Differential fuel rail pressure” the specified value? Differential pressure −30 MPa (− 4351 psi) Go to Step 6. Go to Step 7.