hitachi — DTC: P0089 (Flash code 151) Common rail pressure fault (Excessive pressure feed in supply pump)

Electronic control fuel injection system (Common rail type) 1E-191 Step Action Value YES NO 6 1. Turn the key switch to “OFF”. 2. Disconnect the PCV connector. 3. Check the PCV harness connector terminal for poor contact, intermittent trouble, etc. 4. Disconnect the ECM harness connector. 5. Check the ECM harness connector terminal for poor contact, intermittent trouble, etc. 6. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 10. Go to Step 9. 7 1. Turn the key switch to “OFF”. 2. Disconnect the common rail pressure sensor connector. 3. Check the common rail pressure sensor harness connector terminal for poor contact, intermittent trouble, etc. 4.

Disconnect the ECM harness connector. 5. Check the ECM harness connector terminal for poor contact, intermittent trouble, etc. 6. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 10. Go to Step 8. 8 Replace the common rail (common rail pressure sensor). Note: For work procedure, refer to “Engine section” in the service manual. Is the procedure completed? — Go to Step 10. — 9 Replace the supply pump. Note: For work procedure, refer to “Engine section” in the service manual. Is the procedure completed? — Go to Step 10. — 10 Check the DTC again. 1. Connect all the harnesses. 2. Clear the DTC.

Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 3. Turn the key switch to “OFF” for more than 10 seconds. 4. Test run with the “Preconditions when DTC is set”. 5. Check the DTC. Is the DTC P1093 detected? — Go to Step 2. Go to Step 11.