1E-206 Electronic control fuel injection system (Common rail type) Step Action Value YES NO 5 1. Turn the key switch to “OFF”. 2. Disconnect the barometric pressure sensor connector. 3. Short between the barometric pressure sensor connector power supply terminal and the signal terminal using jump cable. 4. Turn the key switch to “ON”. 5. Check the value for “Barometric pressure sensor” using scan tool. Is the “Barometric pressure sensor” more than the specified value? 4.8V Go to Step 8. Go to Step 6. 6 1. Check for followings in the power supply circuit between ECM and barometric pressure sensor using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note:
If breaker box is not available, refer to “On- board check procedure for sensors”. • Open circuit • High resistance 2. If the trouble is detected, repair or replace as required. Is the trouble detected? — Go to Step 9. Go to Step 7. 7 1. Check for followings in the signal circuit between ECM and barometric pressure sensor using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Short circuit to barometric pressure sensor ground circuit • Short circuit to ground • Open circuit • High resistance 2. If the trouble is detected, repair or replace as required. Is the trouble detected?
— Go to Step 12. Go to Step 9. 8 Replace the barometric pressure sensor. Is the procedure completed? — Go to Step 12. — 9 Is EMPS available? — Go to Step 10. Go to Step 11.