hitachi — DTC: P0107 (Flash code 71) Barometric pressure sensor circuit input is low (open circuit or ground short)

Electronic control fuel injection system (Common rail type) 1E-205 Recovery from failure Poor connection of terminal from connector Unmatched terminals are fitted. Damage of connector lock Poor contact between terminal and wire Damaged harness Visually check the harness for damage. Check the relevant items on the scan tool data display while moving the connector and the harness which are related to the sensor. The variation of the display indicates the faulty part. Refer to “List of diagnostic trouble code” and “About recovery from failure” in this section for recovery from failure.

The conditions to clear the MIL/DTC The present trouble turns to history trouble when the condition is out of the range from DTC set condition (recovery from failure). Using the scan tool, or memory clear switch and diagnostic switch operation enables to clear DTCs. Test description Diagnostic aid Numbers below indicate step numbers in the chart. 3. In the case of present trouble, the “Barometric pressure sensor” displays less than the specified value. If more than the specified value, identify the cause by referring to “Diagnostic aid”. 5.

If the “Barometric pressure sensor” displays more than the specified value when terminals between the barometric pressure sensor connector are shorted, the circuit beyond the sensor is normal including ECM. If the intermittent trouble is suspected, followings may be the cause. Improper connection of harness connector Defective harness routing Worn harness cladding Wire disconnection inside harness cladding Following inspections are necessary to detect these causes. Improper connection of harness connector and ECM connector Step Action Value YES NO 1 Perform the OBD system check. Is the procedure completed? — Go to Step 2. Perform “OBD system check”, and Go to Step 2.

2 Is the scan tool (KW communication) available? — Go to Step 3. Go to Step 14. 3 Check the value for barometric pressure sensor using scan tool. 1. Connect the scan tool. 2. Start the engine. 3. Check the value for “Barometric pressure sensor” using scan tool. Is the “Barometric pressure sensor” less than the specified value? 0.5V Go to Step 4. Go to “Diagnostic aid”. 4 Check for installation condition of the barometric pressure sensor, ECM and coupling connector. 1. Check for play or looseness in the connection. 2. If the trouble is detected, repair or replace as required. Is the trouble detected? — Go to Step 9. Go to Step 5.