1E-208 Electronic control fuel injection system (Common rail type) About barometric pressure sensor Name 1. Power supply 2. GND 3. Signal 1 2 3 TSWG0058 Step Action Value YES NO 16 1. Check for followings in the power supply circuit between ECM and barometric pressure sensor using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Open circuit • High resistance 2. If the trouble is detected, repair or replace as required. Is the trouble detected? — Go to Step 12. Go to Step 17. 17 1.
Check for followings in the signal circuit between ECM and barometric pressure sensor using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Short circuit to barometric pressure sensor ground circuit • Short circuit to ground • Open circuit • High resistance 2. If the trouble is detected, repair or replace as required. Is the trouble detected? — Go to Step 12. Go to Step 8.