hitachi — DTC: P0108 (Flash code 71) Barometric pressure sensor circuit input is high (+5V short)

1E-214 Electronic control fuel injection system (Common rail type) Step Action Value YES NO 10 1. Check the version of ECM software. 2. Rewrite the software if version upgraded is necessary. Refer to “How to use flash tool” in this section for check and rewriting of ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM. Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 12. Go to Step 11. 11 Replace the ECM. Note: EGR valve position learning is required after replacing or rewriting the ECM.

Refer to “Engine Control System, Engine control module (ECM), Installation of ECM” in this section for learning of EGR. Is the procedure completed? — Go to Step 12. — 12 Check the DTC again. 1. Connect all the harnesses. 2. Clear the DTC. Refer to “How to clear diagnosis trouble code (DTC)” of “Procedure of trouble diagnosis” in this section for how to clear DTCs. 3. Turn the key switch to “OFF” for more than 10 seconds. 4. Test run with the “Preconditions when DTC is set”. 5. Check the DTC. Is DTC P0108 detected? — Go to Step 2. Go to Step 13. 13 Check if other DTC is detected. Is other DTC detected? — Go to each DTC diagnosis. Verify repair. 14 1. Start the engine. 2.

Check the display of barometric pressure. Does the display of “Barometric pressure” show error value? 127 kPa (18.4 psi) (Displayed error value) Go to Step 15. Go to “Diagnostic aid”.