hitachi — DTC: P0108 (Flash code 71) Barometric pressure sensor circuit input is high (+5V short)

Electronic control fuel injection system (Common rail type) 1E-215 Step Action Value YES NO 15 Check for installation condition of the barometric pressure sensor, ECM and coupling connector. (Check the barometric pressure sensor circuit for short to +5V line or battery power supply circuit.) 1. Check for play or looseness in the connection. 2. If the trouble is detected, repair or replace as required. Is the trouble detected? — Go to Step 12. Go to Step 16. 16 1. Check the signal circuit between ECM and barometric pressure sensor for short circuit to the power supply circuit or ignition power supply circuit using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note:

If breaker box is not available, refer to “On- board check procedure for sensors”. Important: If the barometric pressure sensor circuit is shorted to the power supply circuit, the sensor may be broken. 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 12. Go to Step 17. 17 1. Check for followings in the ground circuit between ECM and barometric pressure sensor using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Open circuit • High resistance 2. If the trouble is detected, repair or replace as required. Is the trouble detected? — Go to Step 12.

Go to Step 8.