hitachi — DTC: P0113 (Flash code 22) Intake air temperature sensor fault (high voltage fault, open circuit or short to power supply circuit)

1E-228 Electronic control fuel injection system (Common rail type) Step Action Value YES NO 14 Check if other DTC is detected. Is other DTC detected? — Go to each DTC diagnosis. Verify repair. 15 1. Start the engine. 2. Check the display of intake air temperature. Display of intake air temperature is 214°C (419°F) due to back-up mode after fault judgment. Does the display of “Intake air temperature” show error value? 214°C (419°F) (Displayed error value) Go to Step 16. Go to “Diagnostic aid”. 16 Check for installation condition of the IAT sensor, ECM and coupling connector. 1. Check for play or looseness in the connection. 2. If the trouble is detected, repair or replace as required.

Is the trouble detected? — Go to Step 13. Go to Step 17. 17 1. Check the signal circuit between ECM and IAT sensor for short circuit to the power supply circuit or ignition power supply circuit using breaker box or DMM. Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. Important: If the IAT sensor circuit is shorted to the power supply circuit, the sensor may be broken. 2. If the trouble is detected, repair as required. Is the trouble detected? — Go to Step 13. Go to Step 18. 18 1. Check for followings in the signal circuit between ECM and IAT sensor using breaker box or DMM.

Refer to “Breaker box inspection procedure”. Note: If breaker box is not available, refer to “On- board check procedure for sensors”. • Open circuit • High resistance 2. If the trouble is detected, repair or replace as required. Is the trouble detected? — Go to Step 13. Go to Step 19.